Disclaimer

​

Please read before purchasing.

 

This tool is provided solely as an assistive calculation and reference aid for crane and rigging planning activities. It is intended to support competent users by assisting with calculations, equipment reference checks, and planning-related information only.

 

This tool does not create lift plans, design lifting arrangements, engineer lifting solutions, authorise lifting activities, or determine whether any proposed lift is safe, compliant, or suitable for execution. It is not intended to function as a lift planning, engineering, design, or approval system.

 

This tool is intended only as a support aid to assist the user’s own planning process. It is not a substitute for proper lift planning, engineering assessment where required, manufacturer information, applicable standards, site procedures, risk assessment, or the judgement of competent personnel.

 

Output accuracy depends significantly on the accuracy, completeness, and suitability of the information entered by the user. Incorrect, incomplete, assumed, or inappropriate inputs may produce incorrect, misleading, or unreliable results.

 

Users must independently verify all inputs, outputs, assumptions, equipment capacities, manufacturer data, load charts, configurations, rigging arrangements, operational limitations, and any other relevant information before relying on any result produced by this tool.

 

This tool must never be used as the sole basis for creating, reviewing, approving, or executing any lift plan or lifting activity.

 

This tool is intended only for use in compatible supported software environments as specified at point of sale.

 

While reasonable care has been taken in developing this tool, no representation, warranty, or guarantee is given that it is free from errors, omissions, defects, unsuitable assumptions, or other inaccuracies, or that it is suitable for any particular purpose or application.

 

To the maximum extent permitted by law, the developer accepts no liability whatsoever for any loss, damage, injury, delay, cost, claim, or any other consequence arising from the use of, misuse of, inability to use, or reliance on this tool, its outputs, or any information derived from them. Regulatory, technical, and operational requirements vary between jurisdictions, industries, sites, and organisations. Users are solely responsible for ensuring compliance with all applicable laws, standards, codes, procedures, and local requirements.

 

Responsibility for lift planning, engineering review where required, safe execution, correct equipment selection, verification of all calculations, and compliance with all applicable legislation, standards, codes, manufacturer requirements, and site rules remains entirely with the user.